Drives all listed as lsi megasr drivers#
Is there logic in Acronis to include additional drivers from the PC where it is created? In this case, we did create it on the target PC, but it still doesn't work. :megasr: RAID5 support SAS drive supportīonus question: We have seen in the past that bootable media created on a different PC might not work, and that bootable media should always be created on the target PC. :megasr: Device: NCQ: Queue Depth: capacity=0x0 :megaswr: polling for interrupt status timed out for port=5, slot=0 :megasr: Setting the udma mode for atapi device to 4 :megasr: Device: NCQ: Queue Depth: capacity=0xe8e088b0 :megasr: HBA capabilities, S64A: SNCQ: SSNTF: SSS: ISS: SPM: SSC: PSC: NCS: CCCS: EMS: NP: Megasr 0000:00:1f.2: setting latency timer to 64 The MegaCli command line utility can be used to locate a physical disk in an LSI raid array by blinking the disks activity LED. :LSI MegaSR RAID5 version v.2012, built on at 09:23:28 This document describes version 1.0 of LSI Logic Corporation’s Embedded MegaRAID Software and will remain the official reference source for all revisions/releases of this product until rescinded by an update. Seems to me that the hard drives are recognized, but they don't show up as a source or destination for recovery or backup on the bootable media. The hard drives are recognized in Windows, but when we try to test our disaster recovery procedure using bootable media, we are not able to see any hard drives. LSI MegaRAID Software RAID BIOS Version A. Depending on the drive, the drive might only wake up from a deep sleep after a reset of the whole system.
![drives all listed as lsi megasr drives all listed as lsi megasr](https://i1.wp.com/pcsoftz.org/wp-content/uploads/2021/06/Hard-Disk-Sentinel-5.0.0.jpg)
During POST, the LSI Software RAID Configuration Utility automatically detects the installed SATA hard disk drives and displays any existing RAID set(s). The LSI MegaRAID driver (megasr) loads up as a driver (using the linux dd style pre-install driver load option for CentOS). We have three hard drives installed, where two of them are RAID1. To launch the LSI Software RAID Configuration Utility: 1. We have installed Acronis Backup for servers on a PC with LSI MegaSR RAID5.